柯达kodak C-41冲洗流程

—-摘自柯达官方网站

Solution/Step	Time* min:sec	Temperature °C (°F)	Comments
FLEXICOLOR Developer Replenisher LORR —or— FLEXICOLOR Developer Replenisher	3:15	37.8 ± 0.15 (100.0 ± 0.25)	Recirculate and filter. Agitate with nitrogen or turbulation. Film must be completely immersed.
FLEXICOLOR Bleach III Replenisher	4:20 to 6:30	38 ± 3 (100 ± 5)	Recirculate and filter. Agitate and aerate with oilfree air.
Wash	1:05	24 to 41 (75 to 105)
FLEXICOLOR Fixer and Replenisher§ —or— ELECTROSILVE R Fixer and Replenisher LORR	4:20	38 ± 3 (100 ± 5)	Recirculate and filter. Agitate with oil-free air, nitrogen, or turbulation.
Wash	3:15	24 to 41 (75 to 105)
FLEXICOLOR Stabilizer III and Replenisher —or— FLEXICOLOR Final Rinse and Replenisher	1:05	24 to 41 (75 to 105)
Dry	As needed	Not over 60 (140)

* Includes immersion time and transfer time to the next tank. Keep
transfer times to 20 seconds or less.

＃If you increase the bleach and fixer times to 6:30 or longer, you can
extend the bleach and fixer temperature range to 24 to 41°C (75 to
105°F).

※In some processors, a lower wash-water temperature may affect
solution temperatures in adjacent tanks. Longer warm-up times may be
needed. If it affects developer temperature during processing, you may
need to use a higher wash-water temperature.

§ Use a two-stage (two-tank) countercurrent fixer, preferably with the
same time in each tank. Agitation and filtration in each tank are
required. If your processor has a single fixer tank, using in-line
electrolytic desilvering will decrease the safety margin for adequate
fixing.

△If your squeegees are efficient enough to maintain a low fixer carryover,
you can reduce the wash time to 2:10.

相关柯达网站的PDF说明书下载：
1.C41B_Brochure_47018A.pdf
2.KODAK FLEXICOLOR CHEMICALS
3.CONTINUOUS, ROLLER-TRANSPORT, AND RACK-AND-TANK PROCESSORS

如果你喜欢这篇文章, 请订阅我!

Popularity: 6%

Please leave your comment so we know what you think about this article. Trackback URL: 柯达kodak C-41冲洗流程.